Inserts & recycling

Today was day three of my inserts project, and I went “green” by recycling my face plate jig. I bored out the center of the jig, so that  it was a tight fit around the shoulder on the bottom of the inserts.The new jig made drilling the mounting holes very simple after the initial set up, as it acted as a pore mans rotary table. Enjoy the pics, and check back tomorrow to see the finished inserts.

Posted in: Power Tool Woodworking
Part of the Project


  • February 6, 2013

    Love your layout…i think it will be better if you change the snoopy picture..:Plove your color combination..very attractive and eye cathing…

Leave a Reply

Your email address will not be published. Required fields are marked *