Router Table (Pt. 2)

It’s been really cold outside and in the shop  so I haven’t made much progress on the router table, other than rough cutting a few of the major components to size. Since my Bench dog lift arrived on Monday, I was able to get dimensions off of it, so I could  complete the table design (seen below). I think I might need to add some bracing under the top to support the lift, as it’s a lot heavier than I expected (22 lbs. without the router mounted).

routerTable

Posted in: Power Tool Woodworking
Part of the Project

Leave a Reply

Your email address will not be published. Required fields are marked *