sawblade Caddy

A few weeks ago, I came cross this sawblade caddy tip on, and thought since I was runnig out of space in my tool chest, and this caddy was pretty simple that now would be good time to finally make a proper sawblade storage device.  I made the following tweaks to my version:

  1. I used a 3/8″ bolt instead of 1/4″
  2. I used 3/4″ plywood for the backer board
  3. Most importantly, instead of  placing a hardboard separator disk against the bolt, I made a separator disk template that has a recess in it to fit over the bolt.
Posted in: General

Leave a Reply

Your email address will not be published. Required fields are marked *