I finished the case late last week, and started working on the top late Saturday night. One of the things I struggled with, was how to cut a hole in the back of the case for the dust port. I didn’t want to buy a hole saw that would most likely never be used again unless I absolutely needed to. The solution I came up with, was to use an adjustable circle cutter to make a hole in a piece of MDF scrap, I then used the MDF as a template to router the hole into the case.
Circle cutter & template.
The template made it easy to ensure the dust port was flush with the bottom shelf.
Continue Reading…
Friday, I finished up the three bottom storage drawers. The drawer joinery, is another one of details that my design deviates significantly from Norms. For utility drawers like these, that aren’t going to see a lot of daily use I like to use dado & rabbet joints. They’re easy to make on the table saw, & provide a strong mechanical connection.
The following rendering shows a drawer constructed using this joinery method. The drawer sides have a dado cut into both ends, while the front & back have rabbets cut on their ends that fit into the side panel dados. The false front is glued onto the inner front panel.
Rendering of a drawer with a false front, that's held together with dado & rabbet joints.
The following shots show the steps I use to make drawers using dado & rabbet joinery. For reference, the drawer sides are 1/2″ ply, the bottom is 1/4″ ply, and the false front is 3/4″ ply. Before you start, one thing I recommend, is to place indicator marks on key faces. It’s really easy to get a board turned around and cut a rabbet or dado on the wrong side when your running a batch of boards. Indicator marks help prevent this, assuming you remember to pay attention. Trust me, I’ve learned this the hard way many times over.
Continue Reading…
On Friday, the plywood I ordered finally arrived, so construction has commenced. As I mentioned in an earlier post, the main differences between my table and Norm’s are the joints. He’s well known for his use of screws & biscuits. For example he used biscuits to join the case back to the sides and internal dividers, and well I find this method substandard. I chose to use dados, but as you can see below this leads to a scenario where 3 stopped dados intersect with a 4th dado.
Normally stopped dados have to be cleaned up with a chisel, but since these intersect with another dado, a router equipped with a special template bit can do the clean up faster than anyone could do by hand. Check out the following photos you’ll see what I mean.
Continue Reading…
I finished Rebecca’s shoe racks a few days ago, And tonight, I could no longer smell the finish, so it was safe to bring them inside. I had originally thought about finishing them with polyurethane, but at the last minute, I decided to finish them with boiled linseed oil cut with 50% mineral spirits. They didn’t turn out as nice as I would of liked, but Rebecca loves them none the less. The main flaw with the design is the dado joints used to join the top cross beams to the sides. Getting all of them cut to just the right length and thickness was tedious. Ultimately, I spent more time with chisels fine tuning the fit than I would have liked. If I had to do it again, I would use through dovetails.
Last weekend I started making Rebecca some stack-able shoe racks for her closet. I wanted to make them from materials I had on hand (cherry), so after an hour or so of fiddling in Sketchup I came up with the following design. The design is pretty simple, it’s made from 1″ x 3/4″ stock. Something I strive for in all my projects is a minimization of fasteners, thus I only used Dado-and-Tongue, & Slip joints, to hold the racks together.
Continue Reading…
