Machine tool accessory storage

I’m still catching up on the tasks of daily life that went on hold because I was sick, so i haven’t gotten spent much time in the shop over the last week. One thing was able to do though was make a holder for the t handle Allen wrench set I purchased a while back. The set cam with a holder, but i didn’t like it, because it was rather flimsy, and how was designed to mount to the wall seemed rather awkward and prone to failure. Below, you can see what I came up with. I took some scrap 8/4 soft Maple drilled holder holes rounded over all the edges and mounted it to the wall. It’s low profile and not likely coming off the wall anytime soon.

Posted in: Machining

Comments

  • May 24, 2015

    Great job, Dan. I usually prefer a homemade solution such as this as well. Looks good on the wall too.

Leave a Reply

Your email address will not be published. Required fields are marked *